Draytek Vigor2920n User's Guide download pdf (Page 128)

Vigor2920 Series User’s Guide

116

To use PPTP/L2TP as the accessing protocol of the internet, please choose PPTP/L2TP from

Internet Access menu. The following web page will be shown.

PPTP/L2TP Client Mode

Enable PPTP- Click this radio button to enable a PPTP client

to establish a tunnel to a DSL modem on the WAN interface.

Enable L2TP - Click this radio button to enable a L2TP client

to establish a tunnel to a DSL modem on the WAN interface.

Disable – Click this radio button to close the connection

through PPTP or L2TP.

Server Address - Specify the IP address of the PPTP/L2TP

server if you enable PPTP/L2TP client mode.

Specify Gateway IP Address – Specify the gateway IP

address for DHCP server.

ISP Access Setup

Username -Type in the username provided by ISP in this field.

Password -Type in the password provided by ISP in this field.

Index (1-15) in Schedule Setup - You can type in four sets of

time schedule for your request. All the schedules can be set

previously in Application – Schedule web page and you can

use the number that you have set in that web page.

MTU

It means Max Transmit Unit for packet. The default setting is

1442.

PPP Setup

PPP Authentication - Select PAP only or PAP or CHAP for

PPP.

Idle Timeout - Set the timeout for breaking down the Internet

after passing through the time without any action.

IP Address Assignment

Method(IPCP)

Fixed IP - Usually ISP dynamically assigns IP address to you

each time you connect to it and request. In some case, your ISP

provides service to always assign you the same IP address

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 354 355

No comments

Draytek Vigor2920n User's Guide Page 128