Draytek Vigor 2950Gi User's Guide download pdf (Page 20)

Vigor2930 Series User’s Guide

Before starting to configure the router, you have to connect your devices correctly.

1. Connect the cable Modem/DSL Modem/Media Converter to any WAN port of router

with Ethernet cable (RJ-45). The WAN1/WAN2 LED (Left or Right) will light up

according to the speed (100 or 10) of the device that it connected.

2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the router and

the other end of the cable (RJ-45) into the Ethernet port on your computer. The LAN

LED (Left or Right) will light up according to the speed (100 or 10) of the device that it

connected.

3. Connect the telephone sets with phone lines (for using VoIP function). For the model

without phone ports, skip this step.

4. Connect one end of the power adapter to the router’s power port on the rear panel, and

the other side into a wall outlet.

5. Power on the device by pressing down the power switch on the rear panel.

6. The system starts to initiate. After completing the system test, the ACT LED will light

up and start blinking.

(For the detailed information of LED status, please refer to section 1.2.)

Caution: Each of the Phone ports can be connected to an analog phone only. Do not

connect the phone ports to the telephone wall jack. Such connection might damage

your router.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 297 298

No comments

Draytek Vigor 2950Gi User's Guide Page 20