Draytek Vigor 2950Gi User's Guide download pdf (Page 39)

igor2930 Series User’s Guide

Physical Type You can change the physical type for WAN2 or choose Auto

negotiation for determined by the system.

Load Balance Mode If you know the practical bandwidth for your WAN interface,

please choose the setting of According to Line Speed.

Otherwise, please choose Auto Weigh to let the router reach

the best load balance.

Line Speed If your choose According to Line Speed as the Load

Balance Mode, please type the line speed for downloading

and uploading through WAN1/WAN2. The unit is kbps.

Active Mode Choose Always On to make the WAN connection

(WAN1/WAN2) being activated always; or choose Active on

demand to make the WAN connection (WAN1/WAN2)

activated if it is necessary.

If you choose Active on demand, the Idle Timeout will be

available for you to set for PPPoE and PPTP access modes in

the Details Page of WAN>>Internet Access. In addition,

there are three selections for you to choose for different

purposes.

WAN2 Fail – It means the connection for WAN1 will be

activated when WAN2 is failed.

WAN2 Upload speed exceed XX kbps – It means the

connection for WAN1 will be activated when WAN2 Upload

speed exceed certain value that you set in this box for 15

seconds.

WAN2 Download speed exceed XX kbps– It means the

connection for WAN1 will be activated when WAN2

Download speed exceed certain value that you set in this box

for 15 seconds.

WAN1 Fail – It means the connection for WAN2 will be

activated when WAN1 is failed.

WAN1 Upload speed exceed XX kbps – It means the

connection for WAN2 will be activated when WAN1 Upload

speed exceed certain value that you set in this box for 15

seconds.

WAN1 Download speed exceed XX kbps– It means the

connection for WAN2 will be activated when WAN1

Download speed exceed certain value that you set in this box

for 15 seconds.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 297 298

No comments

Draytek Vigor 2950Gi User's Guide Page 39